Preparation before use of intermediate frequency elbow machine

The intermediate frequency elbow machine produced by our company has beautiful design, simple operation and high production efficiency. It is a manufacturer with many years of production experience. When ordering elbow machine equipment in our company, our company will manufacture a pipe fitting equipment that is approved by customers with satisfaction and quality assurance within 60 days.

Before operation, the intermediate frequency elbow machine needs to be prepared to ensure the stability of the intermediate frequency elbow machine, the normal operation of the intermediate frequency elbow machine, the service life of the intermediate frequency elbow machine, and the quality of the elbow pipe fittings produced by the intermediate frequency elbow machine.

Before using the intermediate frequency elbow machine, pay attention to the following:

The grounding wire of the intermediate frequency elbow machine tool must be a flexible wire of no less than 4mm. If the medium frequency elbow machine tool is connected with a voltage exceeding the specified range, make sure that the power is off when pulling the plug-in, and do not use it when testing the control circuit.

When the intermediate frequency elbow machine is plugged, it is not allowed to pull the wire or cable, which can effectively prevent the plug-in from being pulled off. The encoder shall not be impacted by heavy objects. The electrical box of the intermediate frequency elbow machine shall be stored in a ventilated place indoors, and shall not be operated in corrosive gas and dust.

Before using the intermediate frequency elbow machine, carefully check the intermediate frequency elbow machine. It is not allowed to add or change the input system on the intermediate frequency elbow machine without permission. When the power supply of the intermediate frequency elbow machine is adjusted, it is necessary to reconfirm the motor rotation direction to ensure regular maintenance of the intermediate frequency elbow machine during production. This ensures that the intermediate frequency elbow machine is clean and that there is no foreign matter in the sliding groove before use.

Before starting the intermediate frequency elbow machine, it is necessary to check the line position of the oil level, lubricate at the elder lubrication point, check whether the oil pump makes abnormal noise after starting the machine, and adjust the pressure of the intermediate frequency elbow machine using the electromagnetic relief valve, which can ensure that the system pressure reaches the pressure value of the working specification, usually not higher than 12.5Mpa